Magnetic Low Velocity / Loss Headers

Low velocity headers are used to separate hydraulically the boilers from the rest of the system.

In addition to helping maintain a minimum flow through the boiler, they create a low velocity region for system dirt to be deposited and separation of air from the system water. Used in conjunction with a system filter, they are invaluable when connecting a new boiler to an existing system.

Low velocity headers should always be vertical and sized for a maximum water velocity of 0.5 m/s. Low velocity headers are designed to ensure a water velocity of 0.2 m/s or less and for ΔT 10 or 20, so will be suitable for most systems. Fig 2 proposes dimensions for the design of a low velocity header, and Table 2 shows dimensions for a ΔT 10 or 20 system.

lvh

Magnetic Low Velocity/Loss headers + Optional Simplex & Duplex Filters

Magnetic Low Velocity/Loss headers are an extended development from Magnetic Microbubble Air & Dirt Separators. The use of LV/LH's has developed as the norm to be specified in particular with condensing boilers and boilers of low water content where Magnetite and sludge particles can easily block up the system. Some end up being fabricated on site. Whilst not being totally ineffective they do not contain the factory produced internal membranes to cause micro air bubbles to rise to the top and magnetite and dirt to fall to the bottom. This unit includes it all:

magnetic-low-velocity-header Stainless-Steel-Hydronic-Separator-Low-Loss-Header simplex-duplex-filters

British Designed & Manufactured

  • (A) The automatic air eliminator at the top plus a quick bleed valve
  • (B) Boiler flow and return connections
  • (C) The full height internal stainless steel membrane to encourage air to rise and magnetite and dirt to fall.
  • (D) The 1" BSP drain valve at the base for periodic flushing of sludge
  • (E) The demountable/removable base flange for total periodic cleaning (optional item)
  • (F) We can add extra 1/2" BSP female tappings in the flow and return for instruments if required.
  • (G) We can also mount the unit on a base support with the 1" drain to the side (particularly in larger sizes)
  • (H) The magnetic probe in the return removes magnetite even at 5 microns and below.

Most condensing boiler manufactures will advise the use of a filter in the return as close to the boiler as possible. Simplex and Duplex (as shown above) filters and other methods can prove to be very expensive however we can supply these as a total package. The magnetic probe must be periodically cleaned and maintained and with the flushing valve and particularly the removable base flange regular maintenance may possibly eliminate the need to install filters.

Bespoke Magnetic LL/LV Header

The Low Loss Header shown here is a Magnetic Bespoke Model designed with boiler F&R tappings and two sets of system F&R tappings. The principle behind the design saves separate horizontal boiler headers, no requirement for a separate magnetic microbubble air and dirt separator, the unit has an AAV at the top (Not Shown) and a flushing valve at the base. The Magnetic probe for Magnetite removal is contained in the base. The savings on valves and fittings by this method is significant. We can also add a base flange, if required, to make it into a removable/demountable version.

Please consult us with your requirement. We can similarly do various bespoke fabrications on buffer vessels.

magnetic-bespoke-low-loss
Contact Supaflex
Note: Cookies are used on our website. If you continue without changing your settings, we'll assume that you are happy to receive all cookies.
You can find out more about the cookies used on this site in our privacy page.